Keram&Keramik Turkoform Brush Modeling Liquid 250 ml

Turkoform Brush Modeling Liquid 250 ml

Areas of use and features

• A modeling liquid with more elasticity than Keranor and Universal.
• Makes brush spreading, gathering, and side-to-side bending on anatomical forms easier and safer.
• Can be used comfortably on metal-free and metal-supported porcelain crown and bridge work.
• Designed especially for boutique laboratories doing artistic and aesthetic work.
• Tinted with a trace of red to distinguish it from other liquids.
• Does not run while working; offers comfortable paste-consistency modeling.
• Preserves the given anatomical form so you can create more aesthetic crowns.
• Keeps your porcelain powder mix at the same consistency longer without drying out.
• Does not cause shade deviation after firing; fully natural colors are obtained.
• When recommendations are followed, post-firing shrinkage rates are minimal.
• Produces extremely sintered, pore-free, durable porcelain.
• Can be used with every brand of porcelain powder.

Directions and tips

• Place as much porcelain powder as needed on your working glass.
• Drop the modeling liquid onto the powder.
• Mix thoroughly until you reach the desired working consistency.
• If possible, mix with a glass spatula.
• Renew brush rinse water for every job; use distilled water if possible.
• Wash and clean the sponge used to remove excess water from the brush.
• During and after work, blot excess liquid thoroughly with a paper towel, etc.
• Never vibrate — it closes natural particle packing and evaporation gaps.
• When finished, if time allows, rest large bridges 1–2 min on a paper towel, etc.
• Ensure your furnace calibration settings are correct.
• Store at room temperature (0–29 °C).
• Do not refrigerate.
• Follow the recommended program for best results.

Firing reference

• Start temperature: 500 °C
• Pre-dry time: 6 min
• Vacuum start: 500 °C
• Vacuum end: equal to max heat

Packaging: 250 ml plastic containers